I went to a workshop today on weaving with conductive thread. Not something I’ve done a lot of before, but something I’ve had a previous taste of when I did a workshop of making interactive clothes. However, I’ve never done anything with weaving at all, but it always seemed like a fun thing to try.
So the idea was to weave something small and introduce a couple of conductive thread elements in that could be attached to a microcontroller board like a TouchBoard. In fact, it was a TouchBoard in this instance and that was very straightforward to use as it is nice and easy to connect up.
Well the weaving was ok, in fact easier than I expected although I made a few mistakes. Introducing the conductive thread was simple enough, and as you can see I managed to create a little piece of stuff at the end of it. It worked too. I connected it up to the TouchBoard and it worked a treat. In fact, when I got home I connected it to my Ototo board and that was fine too.
So what’s next? I’m not sure actually. I don’t know quite how I’ll take this forward if at all. There are a few possible applications to it, a few ideas bubbling around, but I need to think about them a bit more first.
Let’s see what happens.